I am curious if it is possible to create a new profile from a KPA Profile. Essentially what I would like to do is run some pre and post EQ on a KPA profile, then take a profile of that profile, so that the new profile bakes in those EQ changes, freeing up those two effects slots. Or I would put my DAW in the loop so that I could use Match EQ, and bake that into the new profile.
Another use would be to mix two profiles into a single profile.
It seems like I would have to do this:
- Do a dummy profiling attempt and send the Kemper's "UFO-landing-sound" Profiling signal to my DAW and record it.
- Route my DAW output into the KPA guitar input. Play the "UFO-landing-sound" recorded on my DAW through the Kemper guitar input with the rig I want to profile selected. Record the Kemper's output in my DAW.
- Route my DAW output into the KPA Profiling return jack. Start a new profiling session. As soon as the Kemper's "UFO-landing-sound" starts playing, play the recorded track from the above step, outputting it to the Kemper.
I have heard the Profiler is rather lax about latency. Seems like this is possible, yes?
To mix two profiles together, I would do the same as above but repeat step 2 for the 2nd profile, then mix the two recorded tracks together in my DAW at the mix I want, then perform step 3 using the mixed track.