I would like to have the right side totally unaffected and the left side of my signal completely (i.e.100%) delayed. All I could find on the forum is how to use the free delay, but that always incurs at least 1/4 of the delay on the other side, respectively...
Is that possible?
Is this possible? Delay one side completely?
- froscheimer
- Thread is marked as Resolved.
-
-
hi...as far as I know there is no way to set the delay stomp to have it exiting on one side only. but let's wait for some other which know the matter better than I do, ok?
-
Are you going for a wet/dry feed straight to a PA or how are you planning on using it?
-
Exactly.
-
Great idea. I'll have to boot my kemper up and see.
-
Doesn't look possible, unless you go wet/dry/wet.
In that case you could set Main output to DELAY/REVERB WET
And use monitor out set to STACK for the "dry" sound including the stomps.But it's weird that it doesn't have a Stack / DelayReverbWet setting on the main out. Put this one into feature requests!
-
Set the monitor out or direct out to stack and the main out to delay/reverb wet.
-
Guys, unfortunately this is not possible unless the trick you mentioned, but if I want to do it selectively rig x rig we can't. The way more similar to this I found is to use tap delay, put the bpm as higher as possible, left delay the way you want and put right delay to 1/32.
We all hope that the delay will be improved in the future since it miss a lot of flexibility... it's a 3 years long story here...