Hello all, newbie here. Curious how to setup the Kemper powered version for use with a powered monitor - Yamaha DXR12 specifically (if that makes any difference).
Thanks in advance for any thoughts, tips, or advice!
Hello all, newbie here. Curious how to setup the Kemper powered version for use with a powered monitor - Yamaha DXR12 specifically (if that makes any difference).
Thanks in advance for any thoughts, tips, or advice!
Connect the Monitor Out (not the Red jack Poweramp Out) to the DXR12.
Thanks paults for the quick response! That seems easy enough! Any other tips on the ideal setting for this particular setup? I see a lot of folks run the DXR10...
You're welcome - I'm one of those DXR10 users
If you use the 12 in wedge position, you may want to experiment with the switches on the back of it - low cut choices and EQ Presets.
Not a DXR user but its generally plug and play. Most people go for the DXR10 because its less boomy than the 12 ( that's what I found when I tried them both) and smaller but few tweaks with eq on the DXR or Kemper and you should be rockin..
I found the sonic differences between the 10 and the 12 to be relatively subtle, when the EQ switches on the back are used.
I have a DXR10. I use the left/mono 1/4" input from the monitor out of the Kemper.
I have the volume on the DXR set to just slightly over the -20db mark, and this seems fine for my rock cover band as my sole backline sound source.
I'm a relatively new user of both the Kemper and DXR. I'm going to hook up to FOH for the first time tonight as an experiment.
I found the sonic differences between the 10 and the 12 to be relatively subtle, when the EQ switches on the back are used.
Agred they were subtle and I didn't have time to tweaks when I tried them so I have no doubt you that is the case
Thank you everyone for chiming in with your feedback!
XLR from main left to dxr's mic/line input works great aswell. Never had any issues, super solid piece of gear!