Hello all, newbie here. Curious how to setup the Kemper powered version for use with a powered monitor - Yamaha DXR12 specifically (if that makes any difference).
Thanks in advance for any thoughts, tips, or advice! 
Powered Head & Powered DXR12
- coolfeel
- Thread is marked as Resolved.
-
Connect the Monitor Out (not the Red jack Poweramp Out) to the DXR12.
-
You're welcome - I'm one of those DXR10 users
If you use the 12 in wedge position, you may want to experiment with the switches on the back of it - low cut choices and EQ Presets.
-
Not a DXR user but its generally plug and play. Most people go for the DXR10 because its less boomy than the 12 ( that's what I found when I tried them both) and smaller but few tweaks with eq on the DXR or Kemper and you should be rockin..
-
I found the sonic differences between the 10 and the 12 to be relatively subtle, when the EQ switches on the back are used.
-
I have a DXR10. I use the left/mono 1/4" input from the monitor out of the Kemper.
I have the volume on the DXR set to just slightly over the -20db mark, and this seems fine for my rock cover band as my sole backline sound source.
I'm a relatively new user of both the Kemper and DXR. I'm going to hook up to FOH for the first time tonight as an experiment. -
I found the sonic differences between the 10 and the 12 to be relatively subtle, when the EQ switches on the back are used.
Agred they were subtle and I didn't have time to tweaks when I tried them so I have no doubt you that is the case
-
XLR from main left to dxr's mic/line input works great aswell. Never had any issues, super solid piece of gear!
