Hi! For some reason effects post the stack in slot 3 and 4 do not work anymore. This affects the browser and performance mode and is independent of the effect type or rig used. It occurred suddenly and did not react to a restart of the profiler. The software is up to date. Any ideas? Thanks!
Kemper Stage - cannot enable post effects in slot 3 and 4 anymore?
- stekadon
- Thread is marked as Resolved.
-
Maybe the effects are locked? Check it in rig manager
-
Slot 3 and 4 are before the stack...
-
Maybe the effects are locked? Check it in rig manager
They are not locked. They can be enabled in terms that that light up but they do not sound. Same thing if I drag one effect from slots 1 and 2 post the stack or before the stack to slot 3 or 4 post the stack. All show up and light up normally on the Kemper Stage and in Rig Manager but you do not hear it in slots 3 and 4.
-
-
Does the reverb still work in the post effects?
-
Sounds like you have the Output set to Mod. This taps the signal after the modulation block so bypassing Delay and Reverb blocks.
