I can't imagine, that it has something to do with autoload. Maybe there's a cab programmed at zero volume? Does the input really dies (no signal, no light on the input-led) or is it a volume jump to zero?
I know some people have had this when scrolling through profiles i have once and a reboot sorted it. Does it happen in the same spot every time when scrolling through
a simular thing is happening to my kpa but with the master volume and outputs ( i know what your thinking but please watch video below )
turning the master volume back up does not work i have to physically turn up each individual output volume !!!!
I have had the same thing happening and finally I sent an email to support. Their reply was that the issue has never been reported before. Just to make sure they know about it, I would contact support. My KPA still has this issue, it doesn't do this every time I browse through the cabinets (and amps by the way too). The only chance to get started again, is to reboot. Sometimes, the only chance to try out a desired cab (or amp) is to switch off autoload - then you can browse through all the cabs (and amps) without the input dying on you.
By the way: Autoload to me is rather useless. When autoload is activated (which seems to be the default mode) it's really nasty to browse through the stomp effects (when suddenly there's a nasty distortion stomp on a high gain profile).
Does anybody know how to turn off autoload permanently - so that when I turn the KPA on autoload is turned off? I haven't found anything in the manuals about that.
This came with the 1.8 firme wear
This came with the 1.8 firme wear
Not possible: I am still on FW 1.6.1 and I have this.
And yes, it doesn't happen right away - you have to scroll through 1/4 of the cabs to encounter the sudden silence.
Sounds as though one of the volumes (such as the cab volume) is being locked and is at zero. The other possibility is that the loop is being enabled and locked, and there is nothing connected in the loop. You could jumper the loop and tell if this is the issue ...
Not possible: I am still on FW 1.6.1 and I have this.
And yes, it doesn't happen right away - you have to scroll through 1/4 of the cabs to encounter the sudden silence.
I'll try to recreate this.
I've had the input die on me 3 times now after scrolling through profiles ?????? I never had this happen on 1.7
Yes, I've definately had this. The first time was when I was messing with paults crystalike and changing cabs. Same symptom as you guys. I posted about this in my thread asking for orchestral fx. I think its programming error tbh.
hey guys.
I just played and scrolled through not 40, but 250+ cabinets on autoload and I can't recreate what you are experiencing.
Can someone of you with this problem send me a rig, that behaves as described when used as a starting point?
contact me via pm, please.
thanks.
Display Morehey guys.
I just played and scrolled through not 40, but 250+ cabinets on autoload and I can't recreate what you are experiencing.
Can someone of you with this problem send me a rig, that behaves as described when used as a starting point?
contact me via pm, please.
thanks.
Ive never had it happen when scrolling through cabs but i have scrolling through profiles. 3 times to be exact
Ive never had it happen when scrolling through cabs but i have scrolling through profiles. 3 times to be exact
do you scroll very quickly through the rigs,
do you use the rig buttons or the browse wheel?
does this happen with certain rigs or randomly?
can you give me more info please?
thanks.
I scroll with the browse wheel and when it happened to me I was scrolling quite fast. Its only happened 3 times to me when scrolling through rigs
alrighty, I'll look into it.
thanks.
