Hello,
after spending some more time with the Profiling Feature of my Kemper I got some questions which may be answered from more experienced user.
It took a while to figure out how to easily get the Kemper integrated in my Setup with an Behringer X32 but I found a way to do it somehow comfortably. After trying some Routing Options out I found it best to just connect the Kemper directly to the Amp and do the Rest over the X32 Mixer.
I was able to do some profiling and the Profile I created is kinda close to the Original.
But today I tried to profile my Amp with a very clean sound and after playing around a lot I got the Profile near the Original Amp Sound. Then I tried to compare how the Sound changes when I crank up the Gain on the Amp compared to how it sound when I crank up the Gain from the Profile. I cranked the Gain a lot on both and of course I had to adjust the Volumes from the Signals so it should be easier to compare both Sound.
And the Sound from the Profile didn't really sound ok. The Distortion sounded really bad.
Is this a Common Problem or did I something wrong when I profiled the Amp?
Every Tip and Trick is welcome related to profiling.
Heavy Greetz