Hi,
I've installed the new FW 3.0.0.10845 yesterday. Today I found a new one (10856). Kemper didn't mention anything. Somebody knows what the difference is?
thx
Cyrus
Hi,
I've installed the new FW 3.0.0.10845 yesterday. Today I found a new one (10856). Kemper didn't mention anything. Somebody knows what the difference is?
thx
Cyrus
Hi
its technical the same, no changes
only beta status changed to release
no need to install again
Well, the size of bin file is different too, so some changes should have been made.
Kemper didn't mention anything. Somebody knows what the difference is?
It fixes a small glitch when restoring factory rigs. I recommend updating to 10856 in any case.
Hi
its technical the same, no changes
only beta status changed to release
no need to install again
I recieved this mail, I had Installed version 10845B :
Dear XXXX,
thanks for downloading Firmware 3.0 for your Kemper Profiler.
An important update to the initial release is available for you.
This update addresses a settings related issue and is recommended for
all Profiler users.
-----------------------------------------------------
Download Information:Kemper Profiler Firmware 3.0.0 Release (Build 10856)http://www.kemper-amps.com/page/render/lang/en/p/221/
-----------------------------------------------------
With best regards,Kemper Support
Got the same email, although the version is the same as was available last night (10856)
I got the mail too. Makes me think the update must be important. May be some bugs that users didn't catch but HQ became aware of.
Got the same email, although the version is the same as was available last night (10856)
I've got the email too, copy the caos.bin to the usb stick , insert usb stick into the KPA but no firmware update is starting (Backup / Restore / Format USB)
Try to replug the USB stick. If that doesn't work, copy kaos.bin again and retry. It should work.
Build 10856 is a 3 weeks old version only available in BETA version. But nothing new, still bugs... I think Butkhard told today the modification, but it was a minor one to me.
Try to replug the USB stick. If that doesn't work, copy kaos.bin again and retry. It should work.
no chance, no automatic system update is starting ?
It is possible, that I get the last version during I've upgrade to 3.0 today morning and get the Email after that ??
TheReleas number in the KAP is 3.0.0 1056 . Build 26.2.15 19.09:12 ??
26/02 for the release version but the beta one is 3 weeks old
no chance, no automatic system update is starting ?
It is possible, that I get the last version during I've upgrade to 3.0 today morning and get the Email after that ??
TheReleas number in the KAP is 3.0.0 1056 . Build 26.2.15 19.09:12 ??
I had the same issue - the build number in y Kemper was actually 10856 so I assume its not updating because its the same version. Therefore the email was a mistake...
...I'm assuming...
Firmware updates/checks should be built into rig manager, with a check box that says "beta versions" yes/no
I just did the update yesterday without any problems. Kemper should detect the latest kaos.bin as new firmware.
If it doesn't work, copy the file to the OS folder again.