Hello,
I recently purchased the KPA, after lugging Marshall stacks around and a Roland JC 120, finally, enough was enough, im getting too old.
I play both on a worship team and in a blues band in the Motherlode area by Sonora California.
Played for too may years to list and tried just about every amp out there over those years.
I love the KPA, its size, its capabilities, etc. I Cant say enough about it.
However, I am not a tech. whiz and I actually expected Kemper to provide support, MY BAD,,,
Currently, Im able to hook the KPA up to my Roland JC120, or my Theta 300 watt ISP. which is running my two Peavey 4x12 cabs.
BUT, I Bought the KPA powered version so I don't need an amp head.
Must be something Im doing wrong in hooking the KPA directly to the same 2 regular Passive, Peavey 4x12 guitar cabs that my Theta amp is running ?
I went through the Kemper manual, utube, and actually tried to follow directions for once and still NO luck. I get a very slight sound out of the 4x12 speakers when hooked up directly to the KPA, but that's it.
Can someone possibly run through the settings for me, OUTLET settings, the correct rear connection on the KPA to use, just to verify im connected right, etc.etc. or any other advice you might be able to provide.
I cant imagine im that far off, but I definitely have something setup wrong. It should be kicking up dust.
Hope to hear back from someone,
signed,
in serious need of a KPA education.
OK,,,QUESTION ANSWERED,,, YOU GUYS ARE AWESOME